M-Designer 8.0 Technical Reference Guide - Historique des versions

Jdobbels : /* Font */

2020-03-17T11:13:45Z

‎Font

Jdobbels : /* Type of Zones */

2020-03-17T11:12:35Z

‎Type of Zones

imported>Admin : 1 révision importée

2019-03-06T09:11:30Z

1 révision importée

imported>Gbarret : /* Type of Zones */

2018-11-27T15:08:33Z

‎Type of Zones

Voir les modifications

@@ Ligne 118 : / Ligne 118 : @@
 ===Font===
-In the <b>Police<b> tab, the <b>Generation of XPS</b> fonts by code page field is used to pre-load the XPS fonts by defining one or several code-pages in order to optimise the processing time during the process. The separation character used in the code-pages is " ; ".
+In the <b>Police</b> tab, the <b>Generation of XPS</b> fonts by code page field is used to pre-load the XPS fonts by defining one or several code-pages in order to optimise the processing time during the process. The separation character used in the code-pages is " ; ".
 Note:
 When importing a project, if it is written with a non-registered font, an alert indicates that the font is missing and it will appear in red in the <b>Properties</b> of the<b> affected Zone</b>.
 ===Calculation options===
 Both options present in the Calcul tab define the types of separators used for the thousands and the decimals. This information is used for recovering integer or real values in the application (by memory zones), the <b>calculations</b> made and the display of the results in the preview.

@@ Ligne 701 : / Ligne 701 : @@
 ** <b>Optimized</b>: reproduces the characters located in these positions except for the blanks at the beginning and at the end of these positions. Consequently, the framing to the left or to the right is always observed. There is no shift due to blanks in the spool.
 ** <b>Substitution</b>: used to replace a value of the spool by another one stored in a file called replacevalue.txt. By default, this file is in its blank state in the installation folder of M-Designer. In order to carry out the substitutions, place it in the lgobitmap folder. It must contain the values to be replaced followed by replacement values separated by a tab. This sub-type is addressed in greater detail in paragraph 8.3. Replacing characters.
 ** <b>Translate</b>: used to substitute a value with its equivalent translated into another language. Initially, a Tools/Set Lang type zone is used to define the file which contains the translations. For each Text/Translate zone defined in the template, the program seeks for the entry that matches the value of the zone in the file that contains the translations. This should be found in the lgobitmap folder and its name must begin with “Translate_”.
 ** <b>Compressed</b>: area displaying the recovered text into the allocated space. The text occupies the width of the zone and adjusts the font size between a maximum and a minimum so that the text is displayed completely in the allocated space. If the minimum font size does not display the full text, it is truncated and followed by "..."

← Version précédente	Version du 6 mars 2019 à 09:11
(Aucune différence)