ONYX - 9.0 - KB - Le port map lpr n'écoute pas/en
Différence entre versions
De MappingDoc
(Page créée avec « # Disable Windows Services lpd service # Then, do a <code>netstat –ab > path.txt</code> to check that the port is listening # If this is not the case, you must open t... ») |
(Page créée avec « ===Classic messages=== <code>map_lpr</code> ERROR: The remote server did not respond or sent a NACK for queue selection. ») |
||
| (Une révision intermédiaire par le même utilisateur non affichée) | |||
| Ligne 24 : | Ligne 24 : | ||
# If this is not the case, you must open the port to listen for the service in question in the Windows firewall configuration | # If this is not the case, you must open the port to listen for the service in question in the Windows firewall configuration | ||
| − | |||
| − | === | + | The default listening port is '''515'''. |
| + | |||
| + | |||
| + | ===Classic messages=== | ||
<code>map_lpr</code> | <code>map_lpr</code> | ||
| − | ERROR: | + | ERROR: The remote server did not respond or sent a NACK for queue selection. |
[[Category:FAQ]] | [[Category:FAQ]] | ||
[[Category:Troubleshooting]] | [[Category:Troubleshooting]] | ||
Version actuelle datée du 8 janvier 2025 à 08:26
map_lpr port is not listening
Problem
Nothing prints.
The map_lpr log indicates a problem on the listening port.
The map_lpr service is started but is not listening on the default port.
Solution
Please follow the following steps to restore the listening port.
- Disable Windows Services lpd service
- Then, do a
netstat –ab > path.txtto check that the port is listening - If this is not the case, you must open the port to listen for the service in question in the Windows firewall configuration
The default listening port is 515.
Classic messages
map_lpr
ERROR: The remote server did not respond or sent a NACK for queue selection.
