Sending Resources to Printers

Introduction

Mapping allows you to not always send fonts and overlays to the printer so you can save network bandwidth, which can also be a problem when the printer does not have the resources in its memory anymore.

The MAPRSTPRT command sends resources to the printer.

Configuring which resources to send

Step 1: Configuring the resources

To configure the resources, enter CALL MAP_C022 on a command line in Mapping.

Note: From version 10.1.0, the MAPRSTPRT command has a new *CONFIG value in parameter "Editor name".

Press F6 to create a new association and enter the name of the queue you want to configure.

Next, you can see the list of existing Mapping formats. Enter 1 before each format you want to send the resources for to the printer.

Step 2: Sending the resources

To send the resources configured on the printer, run command MAPRSTPRT:

Specify the name of the editor. In general it is the name of the queue that is used. You can stop and/or restart the Editor. Enter the type of Stop you want:

*PAGEEND attend la fin d’impression de la page en cours *CNTRLD attend la fin d’impression du fichier spool en cours *IMMED arrête l’éditeur sans délai d’attente

Indiquez *YES si vous désirez redémarrer l’éditeur, *NO sinon

Indiquez le nom de la file d’attente configurée pour recharger les ressources.

Notes

Vous pouvez configurer la commande MAPRSTPRT dans le planning des travaux de l’AS/400, en faisant attention que la jobd indiquée utilise les bibliothèques Mapping.

Par exemple, utilisez la jobd MAPDMIDDLE de la bibliothèque contenant les objets Mapping.