OPALE - 10.1 - Utilisation - Gestion des envois de ressources vers les imprimantes/en
Différence entre versions
(Page créée avec « Note: From version 10.1.0, the '''MAPRSTPRT''' command has a new ''*CONFIG'' value in parameter "Editor name". ») |
(Page créée avec « Press F6 to create a new association and enter the name of the queue you want to configure. ») |
||
Ligne 12 : | Ligne 12 : | ||
Note: From version 10.1.0, the '''MAPRSTPRT''' command has a new ''*CONFIG'' value in parameter "Editor name". | Note: From version 10.1.0, the '''MAPRSTPRT''' command has a new ''*CONFIG'' value in parameter "Editor name". | ||
− | + | Press F6 to create a new association and enter the name of the queue you want to configure. | |
En validant, une liste des formats mapping existants s’affiche. Indiquez 1 devant les formats dont les ressources doivent être envoyées à l’imprimante. | En validant, une liste des formats mapping existants s’affiche. Indiquez 1 devant les formats dont les ressources doivent être envoyées à l’imprimante. |
Version du 25 mars 2020 à 10:00
Sommaire
Introduction
Mapping allows you to not always send fonts and overlays to the printer so you can save network bandwidth, which can also be a problem when the printer does not have the resources in its memory anymore.
The MAPRSTPRT command sends resources to the printer.
Configuring which resources to send
Step 1: Configuring the resources
To configure the resources, enter CALL MAP_C022 on a command line in Mapping.
Note: From version 10.1.0, the MAPRSTPRT command has a new *CONFIG value in parameter "Editor name".
Press F6 to create a new association and enter the name of the queue you want to configure.
En validant, une liste des formats mapping existants s’affiche. Indiquez 1 devant les formats dont les ressources doivent être envoyées à l’imprimante.
Etape 2 : Renvoyer les ressources
Pour renvoyer les ressources configurées sur l’imprimante, utilisez la commande MAPRSTPRT :
Indiquez le nom de l’éditeur concerné. En général, c’est le nom de la file d’attente qui est utilisé. Vous pouvez arrêter l’éditeur et/ou le redémarrer. Indiquez alors le type d’arrêt souhaité :
*PAGEEND attend la fin d’impression de la page en cours *CNTRLD attend la fin d’impression du fichier spool en cours *IMMED arrête l’éditeur sans délai d’attente
Indiquez *YES si vous désirez redémarrer l’éditeur, *NO sinon
Indiquez le nom de la file d’attente configurée pour recharger les ressources.
Notes
Vous pouvez configurer la commande MAPRSTPRT dans le planning des travaux de l’AS/400, en faisant attention que la jobd indiquée utilise les bibliothèques Mapping.
Par exemple, utilisez la jobd MAPDMIDDLE de la bibliothèque contenant les objets Mapping.